Table of Contents
Advertisement
8. The status bar (bottom part of the window) indicates the connection status of the HomePlug device. Click the
Encryption tab. You will see a screen like the example below.
9. Enter both the Remote Device password in the DAK Password field and the desired Network Key in the field
provided. Click "Set" to save this value to the remote HomePlug device.
If the DAK Password is left blank, the Network Key will be saved to the local HomePlug device only.
All HomePlug devices must use the same Network Key, or they will not be able to communicate with each
other.
On this screen, you can also click Use default to use the 200Mbps HomePlug AV Ethernet Bridge's default
Network Key.
10. Click Close to exit the PLI-2030 utility.
Setup is now complete.
If your PC is not the device you wish to use with the 200Mbps HomePlug AV Ethernet Bridge, connect the Ether-
net cable from the 200Mbps HomePlug AV Ethernet Bridge to the desired device.
The 200Mbps HomePlug AV Ethernet Bridge Central Management is now ready for use.
Figure 4: PLI-2030 Utility - Encryption Tab
Advertisement
Table of Contents
