Security Button - LevelOne PLI-2030 HomePlug User Manual

2 Security Button

This section describes how to use Security button for configuration in the following situations:
Creating a new security network (Network AB)
Two unassociated adapters (a & b) are forming a new network. (Network AB)
The procedure is as follows:
1. Press and hold the security button on the adapter (a) for 10 seconds and release it when device LED auto re-
boots.
2. Press and hold the security button on the adapter (b) for 10 seconds and release it when device LED auto re-
boots.
3. Press and hold the security button on the adapter (a) for 2 seconds then release.
4. The Power LED on adapter (a) starts to flash.
5. Press and hold the security button on the adapter (b) for 2 seconds then release.
6. The Power LED on adapter (b) starts to flash.
7. After a few seconds, the flashing Power LEDs should stop blink. The new group has now created and configura-
tion is successful.
After pressing security button on adapter (a), user has 120 seconds to press adap-
ter (b) and forming a new group.
Security network allows maximum of two devices only. If user would like to create
groups with more than two devices. Please use utility and simply assign different
Network ID.
Note
Note