Section 3 - Installation; Installing Wire Guides And Drive Rolls - Miller Electric A1D-4RV Owner's Manual

3-1. Installing Wire Guides And Drive Rolls

3
2
Side View
8
Tools Needed:
7/16 in
OM-1580 Page 6
SECTION 3 – INSTALLATION
1
7
5
9
6
4
3
When changing wire size or type,
check drive roll and guide size (see
Table 7-1).
1 Wire Guide Securing Screw
2 Inlet Wire Guide
3 Intermediate Wire Guide
Loosen wire guide screws.
Slide tip as close to drive rolls as
possible without touching. Tighten
screw.
4 Drive Gear
5 Pressure Gear
Drive and pressure gears installed
before unit is shipped from factory.
6 Pressure Gear Assembly
Open pressure gear assembly.
7 Drive Roll
8 Gear Securing Bolt
9 Drive Roll Securing Screw
Install correct drive roll for wire size
and type using supplied hardware.
Close pressure gear assembly.
ST-070 887-E