Makita 9556HP Instruction Manual page 8

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
006113
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
(For depressed center wheel , multi disc /
abrasive cut-off wheel , diamond wheel)
For tool with locking screw type wheel guard
009060
009063
WARNING:
The wheel guard must be fitted on the tool so that
•
the closed side of the guard always points toward
the operator.
1. Wheel guard
1
2. Bearing box
3. Screw
2
3
1. Wheel guard
1
2. Bearing box
3. Screw
2
3
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels. (In some
European countries, when using a diamond wheel,
the ordinary guard can be used. Follow the
regulations in your country.)
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees. Be
sure to tighten the screw securely.
To remove wheel
procedure in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc
1
2
3
006116
WARNING:
Always use supplied guard when depressed
•
center grinding wheel/Multi-disc is on tool. Wheel
can shatter during use and guard helps to reduce
chances of personal injury.
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
006117
To remove the wheel, follow the installation procedure in
reverse.
WARNING:
Only actuate the shaft lock when the spindle is not
•
moving.
8
guard, follow the installation
1. Lock nut
2. Depressed
center
wheel/Multi-disc
3. Inner flange
1. Lock nut wrench
2. Shaft lock