Sony Ericsson XPERIA SO-01D docomo Instruction Manual page 196

Table of Contents

Advertisement

・ If you execute calls, communications
or other function operations while
charging, the terminal may become hot
and the battery status icon may not
indicate charging. In this case, wait
until the temperature of the terminal
drops and charge again.
The notification LED blinks in red and cannot
operate the terminal.
・ When the battery level is low, charge
the battery pack.
Terminal operation
Become hot while operating/charging.
・ While calling, depending on the radio
wave condition or call duration time,
the terminal may become hot. This
condition is not abnormal.
・ While operating or charging, or if you
record video, etc. for a long time while
charging the battery, the terminal,
battery pack and adapter may become
hot. There is no problem about safety
and continue to use it.
The operation time provided by the battery pack
is short.
・ Is your terminal left for a long time
under the state of out of service area?
Out of service area, many powers are
consumed to search available radio
waves.
・ The operating time of the battery pack
-
varies depending on the operating
environment and the secular
degradation of the battery pack.
・ The battery pack is a consumable
accessory. The usage duration of the
battery per one charge decreases
gradually each time the battery is
recharged.
Even the full charge state, when the
P.29
operation time is too short, purchase a
new battery pack of the specified type.
Turning the power off or restarting automatically
happens.
・ If the jack of battery pack is dirty, the
-
contact may become poor and the
power may shut OFF. When it is dirty,
clean the battery pack with a dry
cotton swab etc.
-
No operations are performed even by pressing
the keys on the terminal.
・ Check if you activate the screen lock.
The screen reacts slowly when a button is
pressed.
・ When large amount of data is saved in
the terminal or transferring large-size
data between the terminal and
-
microSD card, the reactions on the
screen may be delayed.
The UIM is not recognized.
・ Check if the UIM installed in the right
direction.
P.30
-
-
P.109
-
P.27
Appendix/Index
194
Continued on next page

Advertisement

Table of Contents
loading

Table of Contents