Set-Up; Inserting Batteries Into The Remote Control; Attaching The Base; Wall-Mounting - AOC LE32D1331 User Manual

Set-Up

Inserting Batteries into the Remote control

Insert two size AAA batteries (supplied) to the diagram inside the battery compartment of the remote control.
1 2

Attaching the Base

IMPORTANT: The Base of the AOC LCD TV must be assembled prior to usage.
1. Place the TV set facing down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any damage to TV set.
2. Take out the stand cover and base. Insert the stand cover into the base as shown in Figure 1.
3. Fix the base assembly lightly on the TV set as shown in Figure 2.
4. Insert the screws to the bottom of the base and use them to tighten the base to the stand, See Figure 3 below for reference.
5. Please refer to the "Important Usage instructions" in the above.
1

Wall-Mounting

Please install on a wall by using a Wall-Mount Bracket (sold separately). Before mounting the TV on a wall, the Table-Top Stand must be removed
from the TV. Follow the simple steps below to remove the Table-Top Stand:
1. Disconnect all the cables from the TV.
2. Gently lay the TV, face down, onto a level and stable surface covered with a thick and soft cloth. Make sure the Table-Top Stand is hanging
over the edge.
3. Remove the screws as shown in the illustration for your model and pull the Table-Top Stand out.
4. Do not remove any other screws from the TV.
5. Do not remove the Table-Top Stand for any reason other than to Wall-Mount the TV.
6. Be sure to store the removed screws and Table-Top Stand in a safe place until you are ready to reattach the Table-Top Stand. Keep the
screws away from small children.
7. For bracket installation, refer to the instruction guide provided by the Wall-Mount Bracket model for your TV. Sufficient expertise is required in
installing this TV, especially to determine the strength of the wall for withstanding the TV's weight.
8. For product protection and safety reasons, AOC strongly recommends that you use the Wall-Mount Bracket model designed for your TV and
the Wall-Mounting of your TV should be performed by AOC dealer or licensed contractor.
1
Note: 100 mm x 100 mm wall mount bracket & M4 screws (Screws length: 12mm and pitch: 0.7mm) are not included. Please contact your local
distributor.
3
2
2
12
3