Temperature Range; Temperature Display; Changing The Temperature Display Brightness - Miele K 14820 SD Operating And Installation Instructions

The correct temperature
If you have adjusted the temperature,
wait for approx. 6 hours if the
appliance is not very full and for
approx. 24 hours if the appliance is
full before checking the temperature
display, as it will take this long for the
display to give an accurate reading. If,
after this time, the temperature is still
too high or too low, you will need to
adjust it again.

Temperature range

The temperature can be adjusted from
2 °C to 9 °C.
The ambient temperature in the room
and the installation location can affect
the time it takes for the appliance to
reach the lowest temperature. If the
ambient temperature is too high, the
appliance may not reach the lowest
temperature.

Temperature display

During normal operation, the
temperature display on the control
panel shows the average temperature
in the refrigerator.
The temperature display will flash if
– the temperature is not within the
possible temperature range (0 °C to
19 °C),
– a different temperature is being set.
18
Changing the temperature display
brightness
The temperature display brightness can
be adjusted to suit the lighting
conditions of the room.
^ Touch and leave your finger on the X
sensor.
^ At the same time, briefly touch the
On/Off sensor (without letting go of
the X sensor).
^ Leave your finger on the X sensor for
another 5 seconds until c appears in
the display.
^ Touch the X sensor repeatedly until d
appears in the display.
^ Touch the On/Off sensor again.
^ The temperature display brightness
can now be changed by touching the
X sensor:
d 0: Maximum brightness
d 1: Reduced brightness
d –: Return to menu.
The old setting lights up, and your
newly selected setting flashes.
^ Touch the On/Off sensor to confirm a
new setting.
^ Touch the X sensor repeatedly until c
appears in the display.
^ Touch the On/Off sensor.
You have now left the settings mode.