Advertisement
%HIRUH <RX 6WDUW
The hard reset switch on the back of your Pocket PC should be switched to
the ON (down) position before you can use your Pocket PC. If this is not
the case, please set it to the ON position.
Make sure that your Pocket PC is switched off.
Unscrew the cap of your stylus. Use the pointed end of the cap to slide
the hard reset switch to the ON (down) position.
you need to perform a hard reset. A hard reset will cause the memory of
your Pocket PC to be cleared.
Always leave the switch in the ON position unless
&KDUJH WKH %DWWHU\
Your Pocket PC contains a rechargeable Lithium Ion battery. The battery
must be charged before you use the Pocket PC the first time. You can
periodically recharge thereafter.
Battery power is monitored by your Pocket PC. Warning messages and
battery low icons are displayed when battery power becomes low. If you
receive a "battery low" warning message, you should save your data and
recharge the battery as soon as possible to avoid data loss.
You can also monitor battery power activity through the "power
remaining" indicator on your Pocket PC. Tap
3RZHU
tab and
to see the indicator.
1RWH
Before using your Pocket PC for the first time, you need to charge
and calibrate the battery.
Charge the battery as follows:
You may need to connect the appropriate converter to the AC
adapter's plug according to your country.
Connect your Pocket PC to an AC power source.
à If you are using the cradle for charging, install the Pocket PC in
the cradle, plug the appropriate end of the AC adapter into the
power connector on the USB cable and plug the other end into a
grounded AC outlet.
à If you are not using the cradle, plug the appropriate end of the AC
adapter directly into the power connector on the bottom of the
Pocket PC and plug the other end into a grounded AC outlet.
6WDUW
6HWWLQJV
6\VWHP
,
, the
*HW 6WDUWHG
Advertisement
