System Settings - Pioneer MVH-X385BT Owner's Manual

Menu Item
HPF SETTING
Cut-off frequency: [OFF],
[50HZ], [63HZ], [80HZ],
[100HZ], [125HZ], [160HZ],
[200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings
(page 6).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings
(page 6).
*3 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
CLOCK SET
12H/24H
[12H], [24H]
18
En
Description
Only frequencies higher than the high-pass
filter (HPF) cutoff are output from the
speakers.
Adjust the volume level for each source
except FM.
Each of the below combinations are set to
the same setting automatically.
• USB, iPod, PANDORA (iPhone), ANDROID,
and APP (iPhone)
• BT AUDIO, PANDORA (Android),
ANDROID, and APP (Android)
Description
Set the clock (page 5).
Select the time notation.
Menu Item
AUTO PI
[ON], [OFF]
AUX
[ON], [OFF]
USB AUTO
[ON], [OFF]
BT AUDIO
[ON], [OFF]
APP (Only for MVH-285BT)
[ON], [OFF]
PANDORA (Not available for MVH-285BT)
[ON], [OFF]
BT MEM CLEAR
[YES], [CANCEL]
BT VERSION
Description
Search for a different station with the same
programming, even if using a preset
station.
Set to [ON] when using an auxiliary device
connected to the unit.
Select [ON] to automatically switch to
[USB] source when a USB device/iPod is
connected to the unit.
Select [OFF] when a USB device/iPod is
being connected to the unit just for
charging.
Set the Bluetooth signal on/off.
Set the Bluetooth APP mode on/off.
Set to [ON] when using the Pandora
function.
Clear the Bluetooth device data (device list,
PIN code, call history, phone book, preset
phone numbers) stored in the unit.
[CLEARED] appears when data is
successfully deleted.
Displays the system version of the unit and
the Bluetooth module.