Spindle And Drive Pulley Split Hub R&R; Fuel Evaporation System - Wright Manufacturing ZTO series Instruction Manual

6.14 Spindle and Drive Pulley Split hub R&R
•
Remove 2, ¼" bolts from split hub and install in threaded holes in hub.
•
Slowly tighten each bolt, alternating as you tighten bolts against the pulley.
•
The hub will separate from the pulley.
•
Replace grade 8 bolts and install in reverse order using the assembly holes to tighten hub onto pulley
and spindle shaft.
Assembly
hole

6.15 Fuel Evaporation System

All Wright ZTO's need to have this mandatory feature.
• Do Not alter or remove.
• Do not fill fuel tanks completely. Fill until level is 1 inch below the bottom of the white
fill neck insert.
• Over-filling could result in clogging the roll-over vent and/or contaminating the purge
canister.
• The vapor canister is located under the seat.
• Inspect and clean dust filter every 500 hrs or annually.
1
Threaded
Assembly
Removal
hole
holes
2
3
1=45410002-FUEL TANK CAP, NON-VENTED, CARB, 3"
2=45410020-FUEL, REMOTE VENT WITH INTERNAL VALVE
3=41410032-FUEL TANK ASSEMBLY, RIGHT, LOW PERM
4=45410005-CARBON CANISTER,Q-09-021
5=41410031-FUEL TANK ASSEMBLY, LEFT, LOW PERM
Not shown
42420002-HOSE, 1/4" ID, FUEL, PER FT
42420004-HOSE, 3/16 ID VENT, PER FT
4
29
Tightening will
separate the hub
from the pulley
Vent /
To
Purge
Tank
Dust Filter
1
2
5