Dacor RNR30NC[-C] Installation Instructions Manual
Dacor RNR30NC[-C] Installation Instructions Manual

Dacor RNR30NC[-C] Installation Instructions Manual

Renaissance electric range with induction cooktop

Advertisement

Quick Links

Installation Instructions

Renaissance
Electric Range
®
with induction cooktop
Models: RNR30NC[-C], RNR30NFC[-C], RNR30NIC[-C] and RNR30NIFC[-C]
RNR30NS[-C], RNR30NFS[-C], RNR30NIS[-C] and RNR30NIFS[-C]
Part No. 108559 Rev. C

Advertisement

Table of Contents
loading

Summary of Contents for Dacor RNR30NC[-C]

  • Page 1: Installation Instructions

    Installation Instructions Renaissance Electric Range ® with induction cooktop Models: RNR30NC[-C], RNR30NFC[-C], RNR30NIC[-C] and RNR30NIFC[-C] RNR30NS[-C], RNR30NFS[-C], RNR30NIS[-C] and RNR30NIFS[-C] Part No. 108559 Rev. C...
  • Page 2: Table Of Contents

    If you have questions or problems with installation, contact your The product data label can be seen through the grill below the Dacor dealer or the Dacor Customer Service Team. For repairs control panel, on the right side. to Dacor appliances under warranty call the Dacor Distinctive Service line.
  • Page 3: Important Safety Instructions

    Use common sense and caution when installing, maintaining or operating this or any other appliance. WARNING Always contact the Dacor Customer Service Team about problems and conditions that you do not understand. Hazards or unsafe practices that COULD result in severe personal injury or death.
  • Page 4: General Safety Precautions

    • Do not touch the outside surfaces of the range during the electric power to the appliance. Dacor is not responsible for self-clean cycle. They will be hot. Venting from the oven may service required to correct a faulty installation. The owner cause the cooktop and backguard to become hot.
  • Page 5: Product Specifications

    Product Specifications Electrical Requirements WARNING (Models Ending with -C) IMPORTANT: Observe all governing codes and ordinances during planning and installation. Contact your local building Range models RNR30Nx-C, RNR30NFx-C, RNR30NIx-C and department for further information. RNR30NIFx-C come with a factory installed 4-wire appliance cord Electrical Requirements (All models with NEMA 14-50P plug.
  • Page 6: Product Dimensions

    RNR30NIx and RNR30NIFx. The trim on models RNR30Nx and RNR30NFx are not compatible with a downdraft vent. Models RNR30NIx and RNR30NIFx are compatible with Dacor downdraft vent model ERV3015 only. x = Finish: C for custom color, S for Stainless...
  • Page 7: Installation Specifications

    This is the suggested • The range may be installed flush to the rear wall. Dacor location. For replacement purposes, the location of the recommends installing a non-combustible material on the rear...
  • Page 8 Installation Specifications Cabinet Cutouts for Self-Rimming Installation (Models RNR30NIx and RNR30NIFx Only) Cutout tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated. Countertop • The self-rimming installation of the RNR30NI[F]x range 1 5/8 (41.1 cm) creates a “built-in” look where the range trim overlaps max.
  • Page 9 Installation Specifications Cabinet Cutouts for Self-Rimming Installation with Downdraft Vent (Models RNR30NIx and RNR30NIFx Only) Cutout tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated. • Trim kit PN ATKR30SR is required for proper installation of a downdraft vent with this range. Countertop 1 5/8 (41.1 cm) •...
  • Page 10: Installation Instructions

    Oven racks (2) GlideRack type, (1) standard type below to select the correct screw size. • Razor blade scraper • Dacor Cooktop Cleaning Cream Sub-Floor Type/ Screw Size Installing the Anti-Tip Bracket Floor Covering Thickness Concrete or wood sub-floor, no floor #8 x 1”...
  • Page 11 Installation Instructions To determine if the base plate is high enough: Determine the location of the range center line and front panel when the range is in its final position based on the Product Dimensions on page 4 and the actual Drywall cabinet/cutout dimensions used for the installation.
  • Page 12: Backguard Installation

    Removing the Oven Door connection of the electrical wiring can cause an electric shock hazard and damage the appliance. Dacor is not To make the range easier to move, remove the door to reduce responsible for damages resulting from improper installation.
  • Page 13 Installation Instructions Connecting Conduit to the Range L1 terminal NOTE: See page 14 for instructions to connect an appliance cord to the range. Neutral terminal If using a 4-wire connection, loosen the grounding screw and remove the neutral to ground jumper link. Jumper link Remove the nut from the conduit strain relief (not included).
  • Page 14 Installation Instructions Electrical Connection (cont.) Connecting the Conduit to the House Electrical Junction Box WARNING • Do not connect the green appliance wire to the neutral (white) supply wire unless local building codes permit. • Do not ground the appliance to a gas supply pipe or hot water pipe.
  • Page 15 Installation Instructions Separate No. 10 (minimum) copper grounding wire Fasten clamp tightly on pipe Connection to house power supply Connection to house power supply Junction box Junction box Wire nut Wire nut 4 places 3 places WHITE WHITE GREEN BLACK GREEN BLACK Conduit to...
  • Page 16 Installation Instructions Electrical Connection (cont.) Slide the end of the appliance cord into the strain relief from the bottom of the box. See facing page. Appliance Cord Connections - Where Local Connect the white (neutral) wire to the neutral terminal in the box.
  • Page 17 Installation Instructions Neutral Neutral Ground 3-Wire Appliance Cord Plug 4-Wire Appliance Cord Plug L1 terminal L1 terminal Neutral terminal Neutral terminal L2 terminal L2 terminal Jumper link Link removed Ground screw L1 wire L2 wire White wire L2 wire Green wire White wire L1 wire Strain relief...
  • Page 18: Side Panel Removal

    Installation Instructions Side Panel Removal (Optional - Installing the Range Model RNR30NI[F]x Only) Peel off the protective layer of plastic that covers the stainless steel surfaces. If the range will be installed with the partial side panels removed: Freestanding Installation Remove the three screws just below the oven opening that Measure from the floor to the countertop and adjust the hold the kick panel in place.
  • Page 19: Re-Installing The Oven Door

    Installation Instructions Re-installing the Oven Door Verifying Proper Operation Remove any packaging from inside the oven. WARNING Slide the oven racks onto the supports inside the oven To avoid personal injury or damage to the door from it chamber according to the use and care manual. falling off its hinges: Prior to operating the range, read the accompanying use and •...
  • Page 20: Installation Checklist

    If you need service, be sure to have the model and serial numbers available when you call. See the inside cover for location. Dacor is not responsible for the cost of correcting problems caused by a faulty installation.
  • Page 21 Notes...
  • Page 22 Notes...
  • Page 24 Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com...

Table of Contents