Profi Le; Signal Input From Optional Board - Sony SRX-T615 Installation Manual

2-2-5. Profile
The setting value of this unit is stored in PC, or the setting value stored in PC is written in this unit.
Screen example
[Profile] [Save]
[Save]: Place a check mark in the setting value to be stored in PC.
[File]: Edit and select the file name to be stored.
. [...] button:
Select the file.
. [SAVE] button: Store the checked setting value in the specified file.
[Load]: Place a check mark in the setting value to be written in this unit from PC.
[File]: Edit and select the file name to be written.
. [...] button:
Select the file to be written.
. [LOAD] button: Write the checked setting value in this unit from the specified file.
n
After loading is executed, be sure to restart this unit by turning the power switch on the rear side of this
unit off and on again.
t
In the case that PC and this unit are connected by Ethernet, PC Communication, Network and IPv6 cannot
be set.

2-2-6. Signal Input from Optional Board

In the case of using an optional board, if you change an input signal at the optional board, it sometimes
appears noise on a screen.
It is recommended to perform the masking for approximately 5 seconds in advance.
2-18 (E)
[Load]
SRX-T615