Before You Begin - Sony HST-SE581 Operating Instructions Manual

Before you begin

Press the 1/u switch on the system to turn it
on.
When the STANDBY lamp on the system is lit
in red, you can turn on the system by
pressing one of the SYSTEM CONTROL/
FUNCTION buttons on the remote.
Turning the power off by pressing
SYSTEM STANDBY on the remote sets the
system to STANDBY mode (the STANDBY
lamp is lit).
If you are not going to use the system for a
long time, be sure to turn it off by pressing
the 1/u switch on the system.
STANDBY
STANDBY
0 )
p ª ·
§
1
4
Using other components
with the remote
You can operate Sony TVs, VCRs and CD
players CDP-C661/CDP-CX571 using the
supplied remote. Press one of the SYSTEM
CONTROL/FUNCTION buttons to select the
component you want to use.
Refer to "Remote button descriptions" on
page 30 for details.
P r
R
0 )
p ª ·
§
SYSTEM
STANDBY
SYSTEM
CONTROL/
FUNCTION
2 3
5 6
Changing the factory
setting of a function
button
If the factory settings of the SYSTEM
CONTROL/FUNCTION buttons don't match
your system components, you can change
them. For example, if you have two CD
players and you don't have an MD deck, you
can assign the TAPE button to your second
CD player.
Note that the settings of the TUNER and
PHONO buttons cannot be changed.
1
Number
4
buttons
7
=
0
1
Hold down the SYSTEM
CONTROL/FUNCTION button
whose function you want to change
(TAPE, for example).
2
Press the corresponding number
button of the component you want
to assign to the SYSTEM
CONTROL/FUNCTION button
(1 – CD player, for example).
Now you can use the TAPE button to
control a second CD player.
To select other functions, refer to the
table on next page.
SYSTEM
CONTROL/
FUNCTION
2 3
5 6
8 9
0
+
)
continued
7 EN