Table of Contents
Advertisement
(ote) diave mel em dats) System
sioyce] acme KOlUmsIcvella
¢ Turn off the power to all equipment to be connected before
making any connection.
+ Note that the red plug of the supplied connecting cord is for
right-channel (R) connection and the white plug for left-
I
——
= (et |i) =
channel (L) connection.
ips:
aie to |! xsl |=
* The connecting cords should be fully inserted into the jacks.
A loose connection may cause hum pickup.
juloe) clelom =>-¢clan}e(z)
mole} cae] om colmmer-lol-m Ol0iele)i ale]
2
Signal flow -
L.INE IN
LINE OUT
to an AC outlet
TC-K890ES
LINE OUT
to a wall outlet
tape deck
tape deck
to an AC outlet
to another
|
i from another
Another tape deck
=
to an AC outlet
Note on the CD DIRECT input terminal
Connecting a CD player or a DAT deck to the CD DIRECT
input allows the sound signal of the connected unit to be
directly input to the unit. Since this shortens the signal path,
the result is higher sound quality. However, due to the
shortened signal path, the BALANCE knob and MPxX filter
are rendered inoperative during input from the CD DIRECT
input. If your CD player is equipped with two sets of outputs,
connect one set to the amplifier and the other to the CD
DIRECT input of this unit. You may then use the INPUT
button to switch between CD DIRECT input or line input to
suit your recording needs.
Advertisement
Table of Contents
