Wen 70716 Operator's Manual page 14

4. Retighten the miter lock (Fig. 15).
WARNING: Be sure to tighten the miter lock before makinga cut. Failure to do so could result in the table
movingduring the cut, causing serious personal injur
5. Loosen the bevel lock (Fig. 16) a
the desired bevel angle (between 0º and 45º). Tighten the bevel lock (Fig. 16).
6. Place the workpiece flat on the tabl
convex side against the fence. If the concave side is placed against the fence, the board could break and jam
the blade.
7. When cutting long pieces of timber, support the opp
work surface that is level with the saw table.
8. Use the clamp assembly to secure the workpiece wherever possible.
9. It is possible to remove the clamp assembly by loosening the clamp assembly lock a
side of the table. Make sure the clamp assembly lock is tight before using the clamp.
10. Before turning on the saw, perform a dry run of the cutting operation to check that there are no problems.
11. Hold the op erating handle (1) firmly and squeeze the switch trigger. Allow the blade to reach maximum speed
and slowly lower the blade onto and through the workpiece.
12. Release the switch trigger and allow the saw b
workpiece. Wait until the blade stops before removing the workpiece
Note: Wear eye protection when brushing dust away.
y.
nd pull out the 0º bevel adjuster and move the saw arm to the left or right to
e with one edge securely against the fence. If the board is warped, place the
osite end of the timber with the sidebars, a roller stand or a
lade to stop rotating before raising the blade out of the
14
nd moving it to the other
.