Axis F41 Installation Manual page 11

1. Cut the cable to the desired length. Measure from the sensor
unit.
2. Strip the plastic outer coating from the end of the cable.
3. Peel back the shield.
4. Flatten the colored wires in the order described below.
1
2
3
4
5
6
5. Insert the wires all the way into a shielded 6P6C RJ12
connector.
NO TICE TICE
NO NO TICE
Make sure that the wires stay in the correct order and that the
cable shield makes good contact with the connector shield.
6. Use a crimping tool to fasten the connector to the cable.
Brown
White/brown
Not used
Not used
White/blue
Blue
11
AXIS F41 Main Unit