Advertisement
To adjust grill burner air shutters and surface burner air shutters (Some
models):
The left hand air shutter controls the rear haft ofthe grill burner orthe rear surface burner.
The right hand shutter controls the front half of the grill burner or the front surface burner.
Slide air shutter backward or forward to
increase or decreasethe size of the air opening.
A_R S HUTrER
screwdriver blade may be required to make
this adjustment. Observe change in flame
A_R_,_-_jL_
"_
appearance as the air shutter is moved.
AJ_SHUTrER_
/--_SSE_SCREWOR_VEnBLADE
Adjustment is satisfactory when a clearly
INSLOTAND]%'VISTWITH
SLIGHT pRESSURE TO ,_LLOW
defined, even blue flame results at the Hi
AIR_HUTrERTOSLIDEEASILY
flame settfng. The snug fit of the air shutter
assures it will remain positioned correctly,
On any burner, closing the air shutter too far will cause the flame to become soft and
yellow tipped. Opening the air shutter too wide will cause the flame to blow away from
the burner ports. Proper adjustment will produce a sharp, clearly defined even. blue
flame.
Lo Flame Adjustment
This appliance has been shipped from the factory with Lo and Meal flame settings
adjusted for use with natural gas and average installations.There is a wide variety of
conditions caused by altitude and gas mixturescontrolled by utility companies which will
vary and affect the gas flame and performance. Adjustments should be made at time
of installation. If conditions change, follow the procedures outlined below to adjust the
Lo setting.
1. Light burner and set control knob for low flame,
2. Remove control knob from valve stem,
CAUTION: Never use a metal blade to pry
knob off. If knob cannot be easily removed
tuck the folds of a cloth dishtowelunder the
knob skirt and pull the towel upward with
steady, even pressure.
3. tnsert a slender, thin-blade screwdriver
into the recess at center of valve stem and
engage blade with slot in adjusting screw.
4. Turn center stem adjusting screw slightly
to set flame size. Note: Turn clockwise to
reduce or counterclockwise to increase
flame size.
5. Replace control knob when adjustment is
completed.
Proper adjustment will produce a stable, steady blue flame of minimum size. The final
adjustment should be checked by turning knob from Hi to Lo several times without
extinguishing the flame. This adjustment, at the Lo setting, will automatically provide
the proper flame size at Med setting.
11
Advertisement
