Miele H387-1BPKAT Operating Instructions Manual page 55

": the Self Clean program was
interrupted during the heating phase.
" ": A temperature sensor is defective.
This is normal.
If the time display has been turned off, the display will remain dark.
If the "Start" and "End" buttons are pressed simultaneously, "12:00" should appear
in the display.
Check whether the program selector is set to "0". The time of day can only be en-
tered when the program selector is set to "0".
Turn the program selector to "0"
and then to "Light".
After 60 seconds the error mes-
sage will go out, and "PYRO" and
the symbol "p" will light up in the
display.
After another 30 seconds the sym-
bol "p" will flash.
Turn the program selector to "0".
The oven is ready to use.
If you still can not operate the oven
or if this error message occurs
again call Technical Service.
The oven can still be used for but,
the catalytic converter will not
work properly and the Self Clean
program can not be selected.
If the temperature sensor fails dur-
ing the cleaning program the oven
door cannot be opened until the in-
ternal oven temperature has
dropped to below 530°F (280°C)
and the "p" symbol flashes in the
display.
55