33 CONTROL LEVER LUBRICATION
A drop of engine oil on all moving parts of the handlebar control levers.
Also, if the twist grip operation is too tight, indicating dryness, lubricate as follows :—
Remove the two screws that retain the two halves of the twist grip body. This
will release the grip so that it can be slid off the handlebar.
Smear the end of the handlebar with high melting point grease and also smear
some round the friction spring and on the drum in which the inner control wire
is wound.
Then replace the grip and screws and fully tighten same.
34 LUBRICATION CHART
Engine oil. Locations :—
1
Main oil tank
7
C o n t r o l lever moving parts
8
Brake rod joints
9
Front prop, and rear stand hinge pins
19
Front chain case
12
Gear box
Hydraulic Fluid Location :—
4
Front forks
Tallow Location :—
Rear chain
5
Illustration 7
Lubrication Chart.
Grease. Locations :—
2
3
10
11
13
16
17
20
Front hub
Rear hub
Magneto chain case
Steering head bearings
Speedometer gear box
Front and rear brake expanders
Brake pedal spindle