Setup - Chicago Electric 62204 Owner's Manual

Setup

read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual�
note: This Plasma Cutter may be shipped with a protective plug
covering the Air Inlet� Remove this plug before set up�
power plug
1� A 6‑50P plug is wired into this item,
rated to 250VAC and 50A�
if the receptacle does not match the plug,
2�
make sure that it is a 230-250Vac receptacle
rated to at least 30 amps.
If the receptacle is rated properly, a qualified
electrician can cut the plug off of this machine
and install a different appropriate 250Vac plug�
Functions
air inlet
(on back)
power
cord
(on back)
air pressure
Gauge
Page 6
power cord
Storage Hook
Figure a
For technical questions, please call 1-888-866-5797.
air pressure
regulator
power cord
Storage Hook
air
Switch
power
Switch
torch
Ground
clamp
ITEM 62204