Operation - Makita BPJ140 Instruction Manual

Battery cartridge replacing signal
When the remaining battery capacity gets
small, the indicator lamp lights up during
operation earlier than enough capacity battery
use.
Accidental re-start preventive function
Even if the battery cartridge is inserted on the
tool with the slide switch in the "I (ON)"
position, the tool does not start. At this time,
the lamp flickers slowly and this shows that
the accidental re-start preventive function is at
work.
To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide it
toward the "I (ON)" position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing the blade
8
7
6
5
012502
CAUTION:
When installing the plate joiner blade, mount the
•
inner flange with the side marked "22" facing
toward you.
To remove the blade, loosen the clamp screw and open
the blade cover. Push the shaft lock and loosen the lock
nut using the lock nut wrench. To install the blade, first
mount the inner flange.
Then mount the blade and the lock nut. Securely tighten
the lock nut using the lock nut wrench. Close the blade
cover and tighten the clamp screw to secure the blade
cover.
CAUTION:
Use only Makita lock nut wrench provided to
•
remove or install the blade.
Always check the depth of groove after replacing
•
the blade. Reajust it if necessary.
1
1. Lock nut
2
2. Plate joiner
3
blade
4 3. Blade cover
4. Inner flange
5. Clamp screw
6. Shaft lock
7. Loosen
8. Tighten
Dust bag
1
2
012503
To attach the dust bag, fit it onto the dust nozzle. If the
dust bag becomes an obstacle to your work, turn the dust
nozzle to change the dust bag position.
When the dust bag is about half full, switch off and
remove the battery cartridge. Remove the dust bag from
the tool and pull the bag's fastener out. Empty the dust
bag by tapping it lightly to remove as much of the dust as
possible.
NOTE:
If you connect a Makita vacuum cleaner to your
•
plate joiner, more efficient and cleaner operations
can be performed.

OPERATION

How to make joints
WARNING:
Always clamp the workpiece to the workbench
•
before each operation.
004589
012504
8
1. Dust bag
2. Fastener
3. Dust nozzle
3