Filling The Salt Reservoir - Miele G 7859 Operating Instructions Manual

Water softener

Filling the salt reservoir

Please only use specialised reactiva-
tion salt, if possible coarse grained re-
activation salt, with granules of approxi-
mately 1- 4 mm. Under no circumstances
must other salts be used, e.g. table salt,
or gritting salt. These could contain
components which are insoluble in
water which could result in damage to
the water softener.
The salt reservoir holds about 2.5 kg of
salt.
Inadvertently filling the salt reservoir
with dishwasher detergent always
causes serious damage to the
water softener.
Make sure that you have picked up
the right packet of reactivation salt
before filling the salt reservoir.
Remove the bottom basket.
Unscrew the salt reservoir cap.
16
Before filling the salt reservoir with
salt for the first time, fill it with ap-
prox. 2.5 litres of water.
Place the funnel provided in place.
Fill carefully with salt, (as it is filled
displaced water will run out).
Clean salt from the screw threads of
the socket.
Screw the cap on firmly.
Run the "COLD" programme D im-
mediately to remove any traces of
salt water from the cabinet.
Important:
If, after switching on, the D (COLD)
programme start is delayed for a few
minutes this is not a fault. The water sof-
tener is being reactivated.