At The End Of A Program; Preparing Your Appliance For An Extended Vacaion; Interrupting A Program - Miele G 2872 Operating Instructions Manual

At the end of a program

At the end of a program the optical
control light flashes slowly with the door
closed.
The optical function light goes out one
hour after the end of a program.
At the end of a program the display
shows Program finished or Drying plus
with the door slightly open (if activated).
,
The steam being released at the
end of the program may be hot.
Use caution.
Dishes tend to chip if removed still hot
from the dishwasher. If the automatic
door opening setting is deactivated
(see "Settings - Drying plus") it is
recommended to open the door
manually to allow tableware to cool
much faster.
^ Unload the dishwasher.
Unloading the lower basket first will
prevent water drops from the upper
basket and cutlery tray (depending on
model) from dropping onto dishes in
the lower basket.
^ Push the baskets in.
^ Turn the dishwasher off o.
The dishwasher continues to use
electricity until turned off with the o
button.
^ Lift the door and push until the catch
engages.
The door will then close automatically.
,
Do not put your hand inside of
the door as it is closing. Danger of
injury.
Preparing your appliance for
an extended vacaion
If you elect to turn off the water to your
home for an extended period of time,
please note that this may not be
enough to reduce the risk of a leak.
To be completely safe, you must
turn off the water supply to each
individual appliance. This means
under the sink for a dishwasher, at
the laundry bib for your washer, etc.

Interrupting a program

A program is interrupted as soon as the
door is opened. If the door is closed,
the program will continue from where it
was interrupted.
,
Open the door with care. The
water in the dishwasher is hot.
Danger of scalding. Before closing
the door again, leave it ajar for
approx. 20 secs. This will enable the
temperature in the wash cabinet to
settle. Close the door firmly until it
clicks into place.
Use
37