Pace Setter G02743 Operating Instructions Manual page 9

SAFETY INFORMATION
• Make sure your extension cord is in good condition. When using
an extension cord, be sure to use one heavy enough to carry the
current your product will draw. A wire gauge size (A.W.G.) of at
least 16 is recommended for an extension cord 50 ft. or less in
length. A cord exceeding 100 ft. is not recommended. If in doubt,
use the next heavier gauge. The smaller the gauge number, the
heavier the cord. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
• After changing bits or making any adjustments, make sure the
setscrew and any other adjustment devices are securely tightened.
A loose adjustment device can unexpectedly shift, causing loss of
control. Loose rotating components will be violently thrown.
• Tools with sharp points are more likely to poke and injure.
ALWAYS remove the tip when done working with the tool. NEVER
store a tool with a tip still inserted in the setscrew collar.
• Carefully handle the tool to avoid chipping or cracking. Fragments
from grout that bursts during operation will fly away at great
velocity, possibly striking you or bystanders.
• NEVER use dull or damaged bits. Sharp bits must be handled with
care. Damaged bits can snap during use. Dull bits require more
force to push the tool, possibly causing the bit to break.
• NEVER start the tool when the bit is engaged in the material. The
bit cutting edge may grab the material causing loss of control and
kick-back.
• If the workpiece or bit becomes jammed or bogged down, turn
the tool "OFF" by the switch. Wait for all moving parts to stop and
unplug the tool, then work to free the jammed material. If the switch
to the tool is left "ON", the tool could restart unexpectedly causing
serious personal injury.
• DO NOT leave a running tool unattended. Turn power off. Only
when tool comes to complete stop is it safe to put it down.
• DO NOT touch the bit after use. After use, the bit is too hot to be
touched by bare hands.
9