7.5.
Remove the A-Board
1. Remove the Tuner unit. (See section 7.4.)
2. Remove two EDGE SADDLES at top of case.
Twist the EDGE SADDLE to press up at the back and pull
down the front side.
3. Remove the screws (×4
Caution :
Press up the case not to touch the leg of clamper to the A-
board.
Pay attention two metal projection
removal and assemble.
6. Remove the GK-Board from Control button.
) and remove the A-Board.
from back side when
7.6.
Remove the Speakers
1. Unlock the cable clampers to free the cable.
2. Disconnect the relay connector.
3. Remove the screws (×2
4. Disconnect the connector (A12). (See section 7.4.)
5. Remove the screws (×2
7.7.
Remove the Control button unit
1. Disconnect the connector (C14).
2. Remove the screws (×2
3. Remove the Control button unit.
7.8.
Remove the GK-Board
1. Remove the Control button unit. (See section 7.7.)
2. Remove the screws (×2
3. Remove the GK-Board MTG. metal.
4. Remove the claw (×3
5. Disconnect the connector (GK1).
19
) and remove the Speaker R.
) and remove the Speaker L.
).
).
).