Before Use - Hitachi DV10DA Nstruction Manual

BEFORE USE

1. Arrange and check the working place.
Check whether the working place is in a proper condition as mentioned in the notes.
2. Attach a bit.
CAUTION: Before attaching a bit, confirm that the switch is locked.
When the attaching a drill or a driver bit to the drill chuck, always use the chuck wrench
and fasten it firmly. There are 3 holes where the wrench is used. Do not fasten tightly only
at one hole. Fasten uniformly at 3 holes successively.
NOTE:
The chuck wrench is attached at the cen-
ter of the body. To remove it, lift it in the
direction of the arrow. After use, attach it
securely in the original position. (Fig. 8)
When installing the driver bit, always
place the driver bit so that the driver bit
flat surface comes into contact with the
chuck claw and fully tighten the chuck
wrench.
3. Check the attachment of the battery.
4. Check the direction of rotation.
If the lever of the switch unit is set to the
side, the tool will turn right when
viewed from the rear. If the lever is set to
the side, it will turn left. (Fig. 1, Fig. 9)
and are indicated on the outer
frame).
CAUTION:
G During operation, the lever cannot
be changed. To change the lever,
always turn off the switch then
change the lever.
Chuck Wrench
Fig. 8
Side
Right and Left
Turn Lever
Fig. 9
Side
17