Batteries - Malem MO4S Instruction Booklet

Batteries

(remove isolating tag if present)
Batteries are provided free of charge by ourselves during manufacture
and units are tested prior to packaging. Batteries are safely secured
within the alarm. They should not be accessed by children.
Batteries should be replaced only by adults.
For model MO3 button size Alkaline batteries AG13 or equivalent.
L1154, SP675H, V357, LR44, H1154, MR44, RW52, PX675, 675RP,
HG13, SR44 or SG13. See diagram on page 12.
PLEASE DO NOT USE ZINC AIR BATTERIES (also known as
hearing aid batteries) AS THEY CONTINUOUSLY DISCHARGE
REGARDLESS OF BUZZING AND ARE UNABLE TO SUSTAIN
POWER TO THE ALARM. (They have a sticker when new and tiny
holes on the +ve side).
Do not allow ribbon to slip between batteries.
For Ultimate 1 Alarm, Model M04 & MO4S, use 2 x AAA Alkaline
batteries (see diagram on page 13 & 14). For Ultimate 1 + Record
Alarm, Model M05, use 3 x AAA Alkaline batteries (see diagram on
page 15). For Model M06, use 4 x AA Alkaline batteries. To change the
batteries, remove the battery cover. Take special care to observe
correct polarity when replacing all the batteries (see diagram on
page 17). Make sure batteries are not loose within the compartment.
Do NOT mix old and new batteries.
Batteries do tend to deteriorate during use and storage and it is
advisable to test the unit before use; this can be simply done by
moistening the finger and touching the sensor or closing the Easy-
Clip© lever. The alarm should always sound, vibrate or light up. If the
unit does not respond, replace the batteries. In use, the batteries
should not be expected to last more than 1-2 months, so it is advisable
to test the unit regularly. Maximum continuous operating time is about
60 minutes per set of button batteries and up to 10 hours for the AAA
Alkaline batteries.
Important - please remove batteries and clean sensor if the alarm
is not going to be used for some time.
6