Instructions For Mo3, Mo4, Mo5 & Mo6 - Malem MO4S Instruction Booklet

Malem Enuresis Alarms
Instructions for the MO3, MO4, MO5 & MO6 alarms.
For Bed-Mat alarms see PAGES 9-11
1. Insert sensor plug into alarm socket making sure the
Easy-Clip© Sensor lever is lifted up (see diagram).
Do not unplug unless for cleaning or replacement.
(Remove battery isolation tag if present)
2. Carefully attach the alarm to pyjama jacket or night
dress close to the shoulder and thread cord inside
top as shown. For small children, loop and tie
cord to shorten length. Attach to material before wearing garment if preferable.
Optional shoulder clips are available for clinics on request if you do not wish to
use the safety pin. (These clips are universal to all the body alarms, see diagram
on page 12). Clip to clothing near shoulder. (Do not use safety pin if faulty)
3. For Vibrating alarms, attach on the inside of close fitting top or T-shirt close to
the collar bone.
4. For VCA (Light Emitting), attach in a position on clientʼs or childʼs clothing where
it can readily be seen by carer or nursing staff. Alternatively, attach alarm to the
end of the bed where it can be seen by nursing staff and secure sensor/mat
under bed sheet.
For Easy-Clip© Sensor: Lift sensor clip lever, attach to the outside of close
5.
fitting underwear, at the location most likely to get wet first, by inserting material
inside sensor jaws at the front and closing lever. (Dispose of insulating tag if
present)
Lowering the lever without any dry material in the jaws will trigger the
alarm and prevent the alarm from resetting. Lift the lever and press the
reset button.
Place underwear material into mouth
(jaws) at the front of the Easy-Clip .
Lock the Easy-Clip
onto the material by
pressing down the lever.
2
IMPORTANT: DO NOT PLACE
ANY MATERIAL UNDER THE
SECURING LEVER.
IMPORTANT:
Regularly CLEAN Easy-Clip
Sensor in soapy water, rinse
and shake dry.