Malem MO4S Instruction Booklet page 5

6.
For Standard Sensor: Cut
off one end of the absorbent
pad and insert the sensor in
between the layers. Anchor
with the crocodile clip to
prevent sensor from being
pulled out. Uncover the
backing strip and stick the
pad inside a pair of close
fitting pants, insuring the
sensor is located where it will come in
contact with the flow of urine.
Boys who prefer not to use pads can
sandwich the sensor between TWO PAIRS of cotton briefs (not boxer
shorts) or place within fold of Y-Front, and anchor by locating the
crocodile clip on the outside below the waistband of the pants.
Adhesive tape may also be used to fasten the sensor plate correctly
in the area of urine flow. The sensor plate and crocodile clip must not
be in direct contact with the skin. Avoid nylon/polyester underwear.
For Bed-Mat Sensor: See instruction on page 9.
7.
Please make sure the sensor plate and
the crocodile clip are attached between
the two pairs of pants and do not come
in contact with the skin.
Outer Pants
Inner Pant
3
PLEASE NOTE THAT
SENSOR & CLIP ARE
GOLD PLATED.