Heatmor 100 CB Instruction Manual page 24

ABSOLUTELY NO FIRE IN THE FIREBOX WHEN PERFORMING THIS REPAIR.
DO NOT PERFORM THIS REPAIR WHEN UNIT WATER TEMPERATURE
IS UNSAFE. ALWAYS WEAR PROPER PERSONAL PROTECTIVE
EQUIPMENT WHEN WORKING WITH WATER AND CHEMICALS.
Maintaining the Correct Amount of Water in the Bladder and in the HEATMOR™
1) Keep your bladder valve closed when filling your stove with water, but open at all
other times. Your bladder should have a small amount of water in it.
Low Water Condition
If the water level is below the bladder port when the water heats up, air will enter the
bladder instead of water. To remove the air from the bladder, follow step 1 above and make
sure there is a good seal.
Next:
1) Open the bladder gate valve.
2) CAREFULLY remove the bladder hose, allowing the bladder to empty its contents.
3) After bladder is empty of air/water, re-attach the bladder hose to the bladder gate
valve and tighten the hose clamp.
Next, follow step 1 above.
NOTE: NEVER LIGHT A FIRE INSIDE THE FIREBOX UNTIL THE WATER JACKET IS
FULL OF WATER, AND SAND HAS BEEN ADDED TO THE BASE TO THE CORRECT
LEVEL.
INSTALLATION SHOULD BE PERFORMED BY A QUALIFIED INSTALLER AND WILL
COMPLY WITH ALL THE REQUIREMENTS OF THE AUTHORITY HAVING JURISDIC-
TION OVER THE INSTALLATION.
READ THROUGH THE ENTIRE OPERATIONS AND MAINTENANCE MANUAL BEFORE
OPERATING YOUR HEATMOR STAINLESS STEEL OUTDOOR FURNACE.
19