Superior TF18NV Installation And Operation Instructions Manual page 17

INSTALLING LOGS, EMBERS AND
LAVA ROCK
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With heater set to Hi, check to
see if flames contact any log. If
so, reposition logs according to
log installation instructions in
this manual. Flames contacting
logs will create soot.
TF Series Burner System - Log
Compatibility Chart
Burner System
Models
TF18NV
TF18PV
TF2430NV
TF2430PV
Figure 20 TF Series Burner System- Log
Compatibility Chart
LTF(18,24,30)-MM LOG PLACEMENT
It is very important to install the logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater or as identified for use
with the heater as shown in Figure 20, page
17. Each log includes reference numbers
formed in the bottom or back of the log. The
126817-01A
INSTALLATION
Fiber Log Concrete
Models Log Models
LTF18-MM LTF18-RS
LTF24-RS
LTF24-MM
LTF30-MM
LTF30-RS
www.SuperiorFireplaces.US.com
Continued
circled number indicates the order it is placed
on the burner system. The remaining numbers
indicate the size burner system the logs are
designed to fit. For example, the first log for
a 24 inch burner system will include a circled
1 and also a 24. The circled 1 indicates this
is the first log to be installed. The 24 indicates
this log belongs to a 24 inch log set. See page
38 for reference numbers detail.
1. Place the rear log (#1) on base assembly
as shown in Figure 37. Log will fit over
right end of burner and rest in middle
of U-burner.
Base
assembly
Figure 37 - Installing Log # 1
1. Place the middle log (#2) in front of the
U-burner and against the edges of the
plate as shown in Figure 38, page 22.
2. Place the front left log (#3) onto the base
assembly between the middle log (#2)
and the grate fingers. The back of the
front left log (#3) will rest against the front
of the middle log (#2). The notch at the
end of the front left log (#3) will fit around
the grate bar. See Figure 39, page 18.
3. Place the front right log (#4) onto the
base assembly between the middle log
(#2) and the grate. The back of the front
right log (#4) will rest against the front of
the middle log (#2). The notch in the end
of the front right log (#4) will fit around
the grate bar. See Figure 40, page 18.
1
''U'' -
Burner
17