Advertisement
DataPage MK2 (USA) Desktop UHF Radio Paging System
Telephone Interface (models NDPMFUSA and NDPLPUSA only)
Note: in the following pages describing the operation and of the system, the symbol
used to denote the STAR key on your telephone, which must be pressed wherever the
symbol appears in the text. On some telephone systems, the # key can be used instead and
may be preferable in some instances. It is advisable to check ALL types of phone used on
your exchange to decide which key works best with each phone type.
Using the system
Numeric pagers
STEP 1:- CONNECT TO SYSTEM
DIAL PAGING SYSTEM EXTENSION NUMBER OR LINE PORT
WAIT FOR SIGN-ON TONES
STEP 2:- ENTER PAGER NUMBER (OR GROUP NO.) TO BE CALLED
ENTER (PAGER NUMBER)
PRESS #
WAIT FOR ACCEPTANCE TONE OR PROCEED
STEP 3: ENTER NUMERIC MESSAGE TO BE SENT COMPRISING 0,1,2,3,4,5,6,7,8,9.
ENTER (NUMERIC DIGITS MAX 20)
PRESS #
WAIT FOR SIGN OFF TONES
REPLACE HANDSET
REJECTED DATA IS SIGNALLED BY A SINGLE LOW BEEP, RE-ENTER DATA FROM STEP 2 OR REPLACE
HANDSET, WAIT FOR TIME OUT AND START AGAIN.
Alphanumeric pagers
Alphanumeric pagers can be used with this system in the same manner as the numeric pagers. NOTE: The unit
must be setup to utilize alphanumeric pagers at the time of purchase.
Alphanumeric messages can be transmitted to the pager using Scope's paging software, Page-Line Pro using
the serial port option of the DataPage II. Additionally you can transmit one of the pre-set alphanumeric
telephone messages programmed in the DataPage II.
Alphanumeric Paging using Pre-set telephone messages
STEP 1:- CONNECT TO SYSTEM
DIAL PAGING SYSTEM EXTENSION NUMBER OR LINE PORT
WAIT FOR SIGN-ON TONES
DPUSA 02/00
Section 2
(THREE NOTES ESCALATING LOW TO HIGH)
(FOUR TONES HIGH,LOW,HIGH,LOW)
(THREE NOTES ESCALATING LOW TO HIGH)
16
(SINGLE MID TONE)
!
is
!
Issue 2
Advertisement
