Advertisement
DataPage MK2 (USA) Desktop UHF Radio Paging System
Type in the pager no. which you wish to activate when contact 1 is triggered.
After making your selection, press ENTER to store; display will change to:
Select a number between 1 - 4 (represents bleep types A,B,C,D) to set the bleep type.
After making your selection, press ENTER to store; display will change to:
Type in the numeric message you wish to appear on the pager. Press ENTER to store. Screen will then run
through the same sequence for contact no. 2 (if selected). When complete, screen will revert to the main
programming menu.
3: Phone
(refer also to Section 2: Telephone Interface
This section is only applicable to models: NDPMF, NDPLP
The telephone interface can be programmed through the keyboard as follows:
Press key 3. The screen will change to display:-
Select a number in the range 1-9 and press ENTER. This will define the number of rings before the system will
pick up the line. Pressing CANCEL will abort the change and return you to the programming menu.
Note, this value refers to the NDPDTMF model only, as the NDPLP version does not ring, but merely picks up
the line.
After pressing ENTER, the display will change to:
Enter a number in the range 2-99 secs. This will adjust the inactivity time (i.e. no button presses) after which the
line will be dropped.
After pressing ENTER, the display will change to:
This number must fall within the range of 1-99 (each unit = 0.1 sec approx.). This will adjust the delay time from
the moment the line is picked up to the time that the sign on tones are generated.
DPUSA 02/00
INPUT 1 TONE:
>
INPUT 1 MESSAGE:
>
)
RINGS TO ANSWER:
>1
INACT'V TIMEOUT:
>
10
ANS TONE DELAY:
>
2
12
(The number shown is just an example)
Issue 2
Advertisement
