Advertisement
DataPage MK2 (USA) Desktop UHF Radio Paging System
4: Serial
This connection is for units supplied with a serial port enabled and must be specified when ordering.
It will not therefore be accessible to the user for systems supplied in the standard configuration.
Press key 4. This sets the serial data communication speed between the transcoder and host. The screen will
change to display:
Enter a number in the range 1-8. 1=300, 2=600, 3=1200, 4=2400, 5=4800, 6=9600, 7= 19200, 8=38400 baud.
After pressing ENTER, the display will change to:
Enter a key in the range 1-3. 1=None, 2=Odd, 3=Even.
After pressing ENTER, the display will change to:
Enter a number in the range 7-8 to set.
4: Serial
After pressing ENTER, the display will change to:
Enter a number in the range 1-2 to set.
After pressing ENTER, the display will change to:
The default setting of the serial port is 9600, N, 8, 1
When supplied in the standard configuration, display will read:
DPUSA 02/00
BAUD RATE (1-8)
9600
PARITY (1-3):
NONE
DATA BITS (7-8):
>8
STOP BITS (1-2):
>
1
Serial Port
Set OK.
Serial Port
Not Active
13
Issue 2
Advertisement
