Table of Contents
Advertisement
9
Change "Transfer Mode" of "Device 1"(Located in the "Number 1"
checked in Step 6) in the "Advanced Settings" tab from "PIO Only"
to "DMA if available" and click [OK].
It is not necessary to restart after setting changes are complete.
10
Right click the IDE channel where the "TANDBERG RDX" is added
to the "Serial ATA Controller" and click the "Advanced Settings" tab
of the Primary IDE Channel Properties.
If "Transfer Mode" is "DMA if available" and "Current Transfer Mode" is "Ultra DMA Mode
4", settings are finished.
58
Advertisement
Table of Contents
