Table of Contents
Advertisement
r Rotate the VOL/PWR
knob to set the volume
level. If no signal is pres-
ent, press and hold in the
MONITOR button (under
the PTT switch) more
than 2 seconds; back-
ground noise will now be
heard, and you may use
this to set the VOL/PWR
knob for the desired audio
level. Press and hold the
MONITOR button more than 2 seconds (or press
the MONITOR button twice) to quiet the noise
and resume normal (quiet) monitoring.
r To transmit, monitor the
channel and make sure it
is clear.
Press and hold the PTT
switch. Speak into the
microphone area of the
front panel (at the lower right corner of the speak-
er grille) in a normal voice level. To return to the
Receive mode, release the PTT switch.
VX-P920 S
O
erieS
Perating
o
peration
M
anual
r Press the (Orange) TOP
SEL key or SIDE SEL
k e y ( a b o v e t h e P T T
switch) to activate one
of the pre programmed
functions which may have
been enabled at the time
of programming by the
dealer. See the next sec-
tion for details regarding
the available features.
r Switch the top panel's
TOGGLE switch to the
[ A ] , [ B ] , or [ Center ]
position to activate one
of the pre-programmed
f u n c t i o n s w h i c h m a y
have been enabled at the time of programming
by the dealer. When this switch is in the [ A ( left )] ,
[ B ( right )] , or [ Center ] position, the feature pro-
grammed (by your dealer) to that switch position
will be activated. See the next section for details
regarding the available features.
17
Advertisement
Table of Contents
