Removing The Connector Cover; Selecting The Default Settings - Sony LMD-1950MD Instructions For Use Manual

Removing the
Connector Cover
When the unit is shipped from the factory, a connector
cover is attached to the PARALLEL REMOTE terminal
(connector).
To use the connector, remove the connector cover as
follows.
Before removing the connector cover, disconnect the
power cord.
1
Remove the screw of the connector cover.
2
Remove the connector cover.
Save the screw and cover, so that you can reattach the
cover if necessary.
Caution
This connector is designed to allow direct contact with
conductive circuits. Weak voltage may be present
because of a failure in this unit. To prevent patients from
touching this connector accidentally, attach the
connector cover when the connector is not being used to
connect to other devices.
18
Removing the Connector Cover / Selecting the Default Settings
Connector cover
Selecting the Default
Settings
When you turn on the unit for the first time after
purchasing it, select the area where you intend to use this
unit from among the options.
The default setting values for each area
5
4
3
3
1 NORTH AMERICA
ARGENTINA
2 LATIN AMERICA
PARAGUAY
PAL&PAL-N AREA
URUGUAY
NTSC&PAL-M AREA OTHER AREA
3 AFRICA AUSTRALASIA
EUROPE MIDDLE-EAST
NTSC AREA
4 ASIA EXCEPT JAPAN
PAL AREA
5 JAPAN
+ +
– –
MENU
+ +
– –
3
1
2
COLOR COMP NTSC
TEMP LEVEL SETUP
Low BETA7.5 7.5
Low SMPTE 0
Low SMPTE 0
Low SMPTE 0
Low BETA7.5 7.5
Low SMPTE 0
Low BETA7.5 7.5
Low SMPTE 0
High SMPTE 0
ENTER USER MEMORY INPUT
R
-