Low Fluid Level; Correct Fluid Level; High Fluid Level; Adjusting Automatic Transmission Fluid Levels - Ford Taurus 2005 Owner's Manual

7. Remove the dipstick and inspect the fluid level. The fluid should be in
the designated areas for normal operating temperature.

Low fluid level

Do not drive the vehicle if the fluid
level is at the bottom of the dipstick
and the outside temperatures are
above 10°C (50°F).

Correct fluid level

The transmission fluid should be checked at normal operating
temperatures 66°C-77°C (150°F-170°F) on a level surface. The normal
operating temperature can be reached after approximately 30 km (20
miles) of driving.
The transmission fluid should be in
this range if at normal operating
temperature (66°C-77°C
[150°F-170°F]).

High fluid level

Fluid levels above the safe range
may result in transaxle failure. An
overfill condition of transmission
fluid may cause shift and/or
engagement concerns and/or possible damage.
High fluid levels can be caused by an overheating condition.

Adjusting automatic transmission fluid levels

Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick and also in the
Lubricant specifications section in this chapter.
Use of a non-approved automatic transmission fluid may cause
internal transaxle component damage.
If necessary, add fluid in 250 mL (1/2 pint) increments through the filler
tube until the level is correct.
If an overfill occurs, excess fluid
should be removed by a qualified
technician.
An overfill condition of
transmission fluid may cause shift and/or engagement concerns
and/or possible damage.
REVIEW COPY
2005 Taurus (tau), Owners Guide (post-2002-fmt) (own2002),
Market: USA_English (fus)
Maintenance and Specifications
DON'T ADD IF IN CROSSHATCH AREA--CHECH WHEN HOT-IDLING
DON'T ADD IF IN CROSSHATCH AREA--CHECH WHEN HOT-IDLING
DON'T ADD IF IN CROSSHATCH AREA--CHECH WHEN HOT-IDLING
DON'T ADD IF IN CROSSHATCH AREA--CHECH WHEN HOT-IDLING
233