(a)
1-2-4. Connecting the Drain Hose
1. After pressing the joint ring (a), insert the drain hose (b) in the drain outlet. (same as pump
model)
2. Install the drain hose about 80~100cm above the ground. (for pump model)
(a)
(b)
1-2-5. Connecting the water supply hose
1. Remove the adaptor from the
water supply hose.
4. Connect the water supply hose
to the adaptor. Pull down part (c)
of the water supply hose. When
part (c) is released, the hose is
automatically
connected to the adaptor, and
makes a 'click' sound.
c
(b)
2. First, using a "+" type screw-
driver, and then
loosen the three screws on the
adaptor.
Next, take the adaptor and hold
parts (a) and (b) with a gap
about 5mm between them.
a
b
5. Connect the other end of the
water supply hose to the inlet
water valve at the washer.
Screw the hose clockwise, all
the way in.
3. Connect adaptor to the
water tap by firmly tighten-
ing the screws.
Then turn part (b), follow-
ing the arrow, and put (a)
and (b) together.
a
b
6. In case that the water
tap is a screw type,
connect a water supply
hose that fits to the tap as
shown.
1-3