Samsung SW85ASP Service Manual page 16

4. WATER LEVEL KEY
(1) The WATER LEVEL key is always valid except for error cases as below.
* Error:
- Water Supply Error
- Drain Error
- Water sensing error
(2) Pressing the Water Level key shows the options in the order as below.
Middle → ● → High → ● → Maximum → ● → High → ● → Middle → ● → Low → ● Extra low → Lowest
(3) When the WATER LEVEL key happen to be touched before the MOTOR starts to rotate after
the water-feeding, the time of water feeding is automatically adjusted to the water level and
so the time is recalculated.
(4) The washing time with any selected water level at each program can be modified only before
the motor starts to rotate. Otherwise, after the motor started to rotate, the wash cycle will be
performed with the washing time which was already set at the old water level regardless of the
water level.
(5) In case of adjusting the washing time by the WAS� key at the (4), the washing time is to be
recalculated with the new time setup, regardless of the water level.
(6) When the water level is not selected, the segment display is "-:--".
When the WATER LEVEL key is pressed, the total cycle time is displayed in the segment.
Default value for the water level is selected medium.
5. RESERVE KEY (DELAY START KEY)
(1) Reserve key-in is available only before entering start-key under the condition of pressing
any program.
(2) Default value of this key is 3 hours.
(3) Each key-in can update the reserved time by 1 hour to the maximum 19 hours.
(4) It's possible to change the reserved time within 10 min after pressing the START key. It's
not valid to change the time after 10 min.
(5) Manual wash time, rinse time and spin time can be adjusted only after pressing the start key
in 10 min. If total working time is over 3 hours automatic reserve process is canceled and
return to the early condition.
● Low ← ● ← Extra low
3-5