5-3. Spin - Nut Repairing Box
5-3-1. Procedure
1. Insert the jig ® into the spin-nut - .
2. Insert the guide pin ¯ into the groove of the
flange - shaft by rotating it to the right and left.
3. Insert the connecting rod ° and handle ± into
the sq uare box. Then turn the handle clockwise
on the axis of the small box to disassemble
(Right-hand thread).*
To disassemble the box, give three to four times
of instantaneous shocks to the handle in the
loosening direction, then disassemble it by turning
the handle when the nut is loosened.
4. To disassemble the box, strike the handle
three or four times-quick shocks to loosen
it-then complete the disassembly by turning the
handle as the nut is loosened.
5. Reassemble in reverse order.
5-5