Specifications; Standard Accessories; Prior To Operation - Hitachi M 6SB Handling Instructions Manual

PRECAUTIONS ON USING TRIMMER
1. Always use the bit of correct shank diameter suitable
for the speed of the tool.
2. Hold the body firmly during operation. Otherwise,
injuries can result.

SPECIFICATIONS

Voltage (by areas)*
Power Input*
No-load speed
Collet Chuck Capacity
Weight (Only main body)
*Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Trimmer guide ass'y ................................................ 1
(2) Straight Guide ........................................................... 1
(3) Template Guide (with two M4 screws) ................ 1
(4) Wrench 17/19 mm .................................................... 1
Standard accessories are subject to change without
notice.
APPLICATIONS
Plywood trimming
Various beveling
Various grooving
Engraving
Cut offs

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Fitting the bit
Refer to "Fitting and removal of the bit" section
given in the following. It is dangerous if the bit is
not fitted to the coIlet chuck securely. Check if the
collet chuck is sufficiently tightened.
3. The bit is very hot immediately after operation.
Avoid bare hand contact with the bit for any reason.
4. Avoid bringing your hand, face, etc., close to the
bit and rotary parts during operation.
5. Exercise caution as the bit remains rotating even
after the switch is turned off. Contact of your hand,
etc., with the rotating bit can result in injuries.
(110 V, 230 V, 240 V)
440 W
30000/min
6 mm or 6.35 mm (1/4")
1.4 kg
5. Cutting using the workpiece edge as a base line
(Fig. 1)
Note that the distance between the machine center
and the hollow differs from the other three distances.
45mm
6. Confirm the spindle lock mechanism.
Confirm that the spindle lock is disengaged by
pushing the push button two or three times before
switching the power tool on. (See Fig. 2)
Tighten
Loosen
Spindle lock
7. RCD
The use of a residual current device with a rated
residual current of 30mA or less at all times is
recommended.
Hollow
45mm
Top view
Fig. 1
Collet chunk
Bit
Fig. 2
3