Taurus Bravissimo 15 Non Stop Manual page 18

lightly greased and the iron could
omit some smoke when plugged in for
the first time. After a few minutes the
smoke will stop.
Filling with water:
- The deposit (J) contains non-
pressurised water, which can be
filled at any moment. This means
that ironing can be carried out
uninterruptedly.
- It is necessary to fill the deposit
with water before using the steam
function.
- Open the lid of the filling entrance.
Fig (4)
- Fill the deposit without going over
the MAX level.
- Close the lid of the filling entrance.
Use:
- Unroll the cable completely before
plugging it in.
- Connect the appliance to the mains.
- Turn the thermostat control until it
is in a position that corresponds to
the desired temperature.
- Do not use temperatures higher than
those indicated on the clothing to be
ironed.
* Temperature for synthetic
fibres (Polyester, Nylon...).
** Temperature for silk, wool.
*** Temperature for cotton.
(Minimum temperature for
ironing with steam)
Max Temperature for linen.
- If the fabric composition
comprises various types of fibres,
the temperature should be selected
that is required for the fibre with the
lowest temperature. (For example, a
fabric that contains 60% polyester
and 40% cotton should be ironed at
the temperature that corresponds to
the polyester).
- Turn on the iron and the heater, by
pressing the corresponding switches.
The respective pilot lights will turn
on. (Fig. 3).
- Wait until the pilot light (C) steam
ready indicator is connected.
- The appliance will be ready to use
for ironing. From this moment, the
pilot light steam ready indicator (C)
will switch on and off automatically,
according to the steam consumption.
You will also hear a slight sound
intermittently, caused by the water
pump that replaces water in the
heater. Continue ironing normally.
- When the water reaches a minimum
level in deposit J, fill it up without
exceeding the maximum level. (Fig.
1)
Ironing with steam:
- Ironing can be carried out with
steam always when the deposit
contains water and the selected
temperature is suitable.
The appliance has a control (H),
which enables the steam control to
be blocked thus obtaining continuous
steam without having to constantly
press the steam blast control.
Steam flow control: (Fig. 3)
- Control (F) on the appliance allows
the steam flow to be regulated.
How to iron in a vertical position
(Fig. 6)
It is possible to iron hanging curtains,
item
To do
- Sel
of th
temp
clock
- Mo
direc
contr
Impo
it's r
base
For o
recom
at so
Once
appl
- Sel
via t
- Un
main
- Rem
Temp
- The
prote
from
C
- Dis
main
unde
- Cle
cloth
liqui
- Do
with
bleac
clean
- Do
wate