Storage; Cleaning Instructions; Tyre/Wheel Replacement - Quantum 610 Owner's Manual

V I I I .

Storage

Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries
from the power chair. See VI. "Batteries and Charging."
WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be
damaged.

Cleaning Instructions

WARNING! Never hose off your power chair or place it in direct contact with water. Your power chair
has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.

Tyre/Wheel Replacement

If you have pneumatic tyres and you have a flat tyre, you can replace the tube. If your chair is equipped with a solid tyre
insert, then you must replace the entire wheel assembly. Replacement tyres, tubes, and wheel assemblies are readily
available through your Quantum Rehab Specialist.
WARNING! To avoid possible injury, be sure that the controller's power is turned off and the
power chair is not in freewheel mode before performing this procedure.
WARNING! Completely deflate the tyre before attempting repair.
Follow these easy steps for a quick and safe repair for both pneumatic and solid tyres:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tyre, completely deflate it
before removing the wheel.
4. Remove the drive wheel nut from the wheel hub.
5. Pull the wheel off the axle.
6. Remove the screws that fasten the two rim halves together.
See figure 35.
7. Remove the old tube from the pneumatic tyre and replace it
with a new tube or replace the entire assembly if it is a solid
tyre.
8. Screw together the two rim halves.
9. Slide the wheel back onto the shaft. Make sure that the key is
in the axle slot.
10. Reinstall the drive wheel nut onto the wheel hub and tighten.
11. Inflate the pneumatic tyre to 35 psi (2.4 bar).
12. Remove the power chair from the blocks.
50
C A R E A N D
www.quantumrehab.com
M A I N T E N A N C E
WHEEL HUB
REAR RIM HALF
FRONT RIM HALF
Figure 35. Quantum 610 Drive Wheel
TYRE
WASHERS
NUTS
Quantum 610