Multi-Axis Foot Plate; To Adjust The Leg Rest Length; To Change Leg Rest Length; To Change Foot Plate Position - Quantum 610 Owner's Manual

V . C O M F O R T

To adjust the leg rest length:

1. Remove the adjustment screws from the leg rest exten-
sion.
2. Slide the leg rest up or down to the desired length.
3. Align the adjustment holes in the leg rest extension and
reinstall the adjustment screws.

MULTI-AXIS FOOT PLATE

The multi-axis foot plate assembly can be installed on either
a swing-away footrest or an elevating leg rest. The multi-
axis foot plate has four adjustments: leg rest length (A),
position (B), tilt (C), and angle (D). See figure 25.
To change leg rest length (A):
1. Remove the hardware.
2. Move the leg rest to the desired position.
3. Reinstall the hardware.
To change foot plate position (B):
1. Remove the hardware.
2. Move the foot plate to the desired position.
3. Reinstall the hardware.
To change foot plate tilt (C):
1. Loosen the hardware.
2. Tilt the foot plate to the desired position.
3. Tighten the hardware.
To change foot plate angle (D):
1. Turn the setscrew clockwise to decrease the angle.
2. Turn the setscrew anticlockwise to increase the angle
Quantum 610
A D J U S T M E N T S
A
.
C
SETSCREW LOCATION
Figure 25. Multi-Axis Foot Plate (ELR Shown)
www.quantumrehab.com
A
B
D
B
C
D
27