GE ZDIC150 Owner's Manual page 8

Remove
IMPORTANT: Do not remove any permanent
packaging instruction labels inside your icemaker or the
Tech Sheet that is fastened behind the lower
access panel.
• Remove tape and any labels from your
To remove any remaining tape or glue, rub
the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing
a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm
water and dry.
Clean before
After you remove all of the packaging materials,
using
clean the inside of your icemaker before using it.
Set controls
1. To start the normal ice making cycle,
2. To stop icemaker operation, press and
8
icemaker before using (except the model and
serial number label).
select ON.
OFF.
Controls and Features
Icemaker
• Do not use sharp instruments, rubbing alcohol,
flammable fluids or abrasive cleaners to
remove tape or glue. These products can
damage the surface of your icemaker. For
more information, see Important Safety
.
Instructions
See the cleaning instructions in Care and
Cleaning.
NOTE: The CLEAN setting is used whenever
solutions are circulated through the icemaker
for cleaning. See Care and Cleaning.