Settings 2 Menu - Eiki EK-400X Owner's Manual

Settings 2 Menu

Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the
Settings 2 menu. Press the cursor ▲▼ button to move up and down in the Settings 2 menu.
I
TEM
Auto Source
No Signal Power
Off (min.)
Auto Power On
Lamp Mode
Reset All
Status
Advanced 1
Advanced 2
Note :
"Dynamic ECO": Press BLANK button, Lamp will dim to 30% automatically.
Press the cursor ◄► button to enter and enable or disable automatic source
detection.
Press the cursor ◄► button to enter and enable or disable automatic shutdown of
lamp when no signal.
Press the cursor ◄► button to enter and enable or disable automatic power On when
AC power is supplied.
Press the cursor ◄► button to enter and select the lamp mode for higher brightness
or lower brightness to save lamp life.
Note:
Remarks to Dynamic ECO of ImageCare
1. Shut-down is not allowed when the projector is boot up less than one minute
2. To protect the lamp, when a shut-down command is received, the lamp mode is forced to be
reset to "Normal" and the system will automatically shut down 10 seconds later
(Enter) / ► to reset all settings to default values.
Press
(Enter) / ► to enter the Status menu. See page 33 for more information on
Press
Status.
(Enter) / ► to enter the Advanced 1 menu. See Advanced 1 Feature on
Press
page 34.
(Enter) / ► to enter the Advanced 2 menu. See Advanced 2 Feature on
Press
page 46.
D
ESCRIPTION
TM
— 32 —