To Activate Remote Control - Dirna bycool Dinamic 1.1 User Handbook Manual

DINAMIC 1.1

TO ACTIVATE REMOTE CONTROL

- The equipment being switched off, keep the
flashing. Once it remains fixed, touch any key of the control and it will recognised.
C
If no control key is pushed during 30 seconds, the equipment will stop. (It is possible to
programme up to 5 controls for one single item of equipment).
TO DISABLE REMOTE CONTROL
- In order to erase any programmed control, continuously press the
then press the
C
shows
All activated controls are automatically cancelled (do not wait more than 30 seconds between
pressing one key and the other or equipment will be switched off).
ca will appear on display. alternatively whith the selected temperature. If temperature is
above 32º inside vehicle, when equipment is switched on, blower and compressor go into
maximum power for about 20 minutes, then blower and compressor regulate their capacity
depending on inside temperature.
By pushing , one key or the other, desired temperature is chosen, between 15º and
27º C - 59-80º F
With this function, compressor goes into maximum power with minimum air speed.
Compressor is activated or desactivated according to temperature selected on display.
By maintaining
display. Release on desired speed.
By maintaining
display. Release on desired speed.
By pushing only once, one key or the other, desired temperature is chosen, between
15º and 27º C - 59-80º F
key.
F4 Automatic functioning
F0 Manual functioning
, pushed, blower speed increases and U1, U2, U3, U4, U5 appear on
, pushed, blower speed decreases and U1, U2, U3, U4, U5 appear on
Air conditioning for vehicles
plate key pressed until display shows
7
EN
plate key until display