Install Clock Backup Battery - iHome iHM46 Instruction Manual

Instruction manual for alarm clock

Hide thumbs

Table Of Contents

Table of Contents

PM/AM

Indicators

Volme adjust

Indicator

Snooze

Indicator

The iHM46 uses a CR2032 button cell battery (included with

instructions) to keep alarm and clock settings in the event of a power

failure and 4 "AA" batteries, not included, for portable operation.

If the Backup Battery has been installed and a power failure occurs or

the AC adaptor is accidentally disconnected, the display backlight will

not remain lit, but current time and alarm time settings will be

temporarily maintained. Otherwise, you must reset the time and alarm

settings. If 4 "AA" batteries are installed, alarm will operate when unit

is not connected to AC adaptor.

1. Please make sure the AC adaptor is connected. Otherwise all

settings may be lost during battery replacement.

2. Open and remove the battery compartment door located on the

bottom of the unit.

3. Pinch the backup battery release tab and pull the backup battery holder free.

4. Insert the included CR2032 button cell battery with the + side facing upwards.

5. Replace the backup battery holder into the unit, then replace the battery compartment door.

Notes:

• Make sure you dispose of battery properly (see your local regulations).

• Buttons will not function if only back up battery installed.

• Replace the CR2032 battery when you see the Low Battery indicator ﬂashing in the display.

Time Display

Low Backup

Battery Indicator