Mackenzie MacFi-se User Manual page 7

Step 1 –
Make all desired power, audio out, configuration
switch and I/O connections to the unit and power up. Unit will
perform a self test and enter idle mode.
Step 2 –
Provide a momentary or maintained contact closure
between the message input (Connector 1, terminals 2-9) and
common (Connector 1, terminal 1). Message Number Display
will show the message number during playback.
Step 3 –
Provide a momentary contact closure to the stop
input (Connector 1, terminal 10) to stop playback and return to
idle mode, or allow message to play to end and the system will
return to idle mode.
The MacFi-se will ignore an input which corresponds to an
empty or corrupt message location. The Play relay contact will
be maintained for the duration of play sequence. When playing
multiple messages through queued messages or via maintained
start activation's, the system will drop the play relay for
approximately 100mS between sequences.
3.5 Memory Clear/Test
Use this procedure when you wish to clear system memory of
previously recorded messages or format the internal SD Card
Step 1 – Remove power from MacFi-se
Step 2 – Depress and hold Record Setup button while restoring
power to MacFi-se. Continue to hold Record Setup button until
Record Indicator remains ON, at which time it may be
released. Record Indicator will remain ON and Status Display
will read FC while system runs audio memory check. This
process could take several minutes.
Step 3 – Wait until Record Indicator turns off, indicating memory
check is complete and unit will perform as usual. -or-
Remove and reapply power to bypass memory test.
3.6 Erase Message
Individual message locations may be erased by simply recording
a short (<1 second) message to that location. This short
recording will instruct the system to erase the data from that
message location.
22
Remote Activation I/O:
Control Inputs: Record, Stop, Sync, 8 individual message
Start contacts.
ICM-25(Option): Add to the MacFi-se for 25 more start inputs
per module.
Status Outputs: Playing, Sync
Output Type: Dry relay contact, 1A @ 24VDC non-
inductive load
Connection: Pluggable terminal
Mechanical:
Package: 3 Way wall mount chassis,
10" W x 8" D x 1.5" H
Material: 18 gauge cold rolled steel chassis; black
painted finish, white silkscreen
Rack mount(option): 1U adapter
Regulatory Agency Approvals:
FCC, Part 15, Class A; UL/CSA approval on external power
pack(sold separately)
Serial Interface:
Type: RS-232
Mode: 9,600 or 115,200 baud, 8 data bits, 1 stop
bit, no parity, no flow control
Commands: Play, Record, Stop, File Download, Status,
etc. (See Table 4.1)
Connection: 3 pin pluggable terminal
Sync Input:
Interface: 10k ohm, RCA
Mode: Audio sensor detects tones 100mS in
duration
7